76 Kurtis

D

Disturbed

Active member
9e085035f7d915f75f95bb5622b5e7ab.jpg


Port lines installed.


Sent from my iPhone using Tapatalk
 
J

jimsplace

Active member
DISTURBED said:
I've already had them off twice since this pic.  crazy.gif  Trying to get the lines all routed properly.
Click to expand...

Trying to get them routed?
It looks like they'll only go one place.

Are you going to run a Burst Panel or a pop-off?
 
D

Disturbed

Active member
jimsplace said:
DISTURBED said:
I've already had them off twice since this pic.  crazy.gif  Trying to get the lines all routed properly.
Click to expand...

Trying to get them routed?
It looks like they'll only go one place.

Are you going to run a Burst Panel or a pop-off?
Click to expand...

You would think so but, you can put the top ones on the bottom and the bottom ones on top.  crazy.gif

Burst panel.
 
J

jimsplace

Active member
Mine was set up a burst panel and I changed it out for a pop-off.

I don't know what kind of pressure you're running, but if the burst panel goes, the motor isn't going to run until it's replaced.
My thinking was that with a pop-off, if nothing else is hurt, the motor will get you back.
The pop-off will also release minor backfire pressure to protect the rotors and butterfly plates. IMO

If you're running big boost, then the burst panel is the way to go.
 
J

jimsplace

Active member
It looks really good sitting on the table.
I have a lot of stuff like that.  You know, sitting on the table for a long time.


When does it get moved to someplace useful, like on the motor?
Seriously, I'm glad to see it arrive and it looks nice.
    :smile17:
 
D

Disturbed

Active member
This project is officially paused.  Luckily, I haven't taken the old engine out just yet so, I still have a boat to play with this summer.  We're closing on a new house next month.
 
You must log in or register to reply here.
Top