Project X

spd500

spd500

New member
I don't have motor mounts , I have a four point . But I could use the motor mount holes on the block , but it still has to be out of the way of the dip stick and the starter on the right side of the motor . Left side is easy , nothing in the way at all .
 
B

blazeracer

New member
spd500 said:
Is that smallest stainless line the aftermarket dipstick that you are using ?
Click to expand...

Yes, it's a Lokar. The top secures to the exhaust riser. It's a real good setup. I WAS going to mount them to the motor mount bolt holes but that was an impossible endeavor. There was no way to get them and two sets of motor mount bolts with nuts all lined up in the tight little space where they reside. The easy fix, I just welded the tabs to the motor mounts also.
 

Attachments

  • IMG_20120407_103156.jpg
    IMG_20120407_103156.jpg
    86.5 KB · Views: 128
spd500

spd500

New member
Sometimes the most simple solution is the best one  :smile30: finally got the coils packs mounted where the starter still fits and I can get to the dipstick  jump.gif
 
4

460rogers

New member
quote author=spd500
CJ has been missing lately  think.gif I hope he didn't drop the top half of the Chrysler on himself trying to get it put back together  think.gif

Nah , that would require him actually working on getting the boat back together  crazy.gif
[/quote]



How's YOUR boat running? crazy.gif
 
spd500

spd500

New member
I need to replace the focking starter in the morning , but other than that it should be good to go .  I am hoping to be on the lake tomorrow and Monday as long as I can get a starter in the morning .
 
spd500

spd500

New member
Turns out my carb was missing some pieces  :smile19: I bought a new carb and should be on the lake tomorrow  jump.gif
 
S

soldier of fortune

New member
spd500 said:
Turns out my carb was missing some pieces  :smile19: I bought a new carb and should be on the lake tomorrow  jump.gif
Click to expand...

what was it missing? i'll give ya your money back, wait a minute i gave it to you for free think.gif
 
spd500

spd500

New member
The squirters are not in it . I am thinking might put the the ones from the new carb on this one and go with it .
 
spd500

spd500

New member
It's a dual feed single plumper . No big deal . Should be enough for this motor for now . I can order the squirters for the 750 on Tuesday .
 
spd500

spd500

New member
The new carb is a 670 street avenger Holley . I will swap it in the morning and go run the boat , it should be enough for this little motor .
 
You must log in or register to reply here.
Top