Condor Tx-19

Devilman

Devilman

Well-known member
damn. guess you could run ya some flex pipe. :grin:

119131d1274993428-need-old-school-exhaust-ideas-exhaustcover.jpg
 
K

KONA77

New member
I've got a cutting rig,  we can put a cherry bomb on the torch and heat the tubes and bent them where they need be  :smile16:
 
duanehydro

duanehydro

Active member
Devilman said:
damn. guess you could run ya some flex pipe. :grin:

119131d1274993428-need-old-school-exhaust-ideas-exhaustcover.jpg
Click to expand...
Actually, that's what was on it...4" tractor stainless flex...but my distance is too short for them. I have a plan, Brent's were worse.
 
duanehydro

duanehydro

Active member
Need to remove about 2" off each tip, and an 1" off the headers, with the soft wet exhaust hose, It should make the bends..that's the plan, anyway.
 
Devilman

Devilman

Well-known member
I got ya, don't see why that wouldn't work. I did see some other flex pipe deals when I was looking for that picture. They are short & look like large diameter braided hose basically. Didn't see any bigger than 3" though.
 
Crusader

Crusader

Moderator
Ya know, maybe it's just me....but I don't think I'd use that metal flex tubing for exhaust. There's just too much water going through the tubes for me to trust something as rigid as a flex tube would be. Yes, I said rigid....because over time the vibration etc would cause it to crack.

Using the exhaust tube with maybe 45degree angles (or whatever angle) would seem to work better....

I dunno....just putting in my $.01
 
73 Sanger Flat

73 Sanger Flat

Active member
Duane "Stuart Hose"  sell that hose you will need by the inch .. I had to get some for my old Ski Boat ..
http://www.stuarthose.com/
 
You must log in or register to reply here.
Top