1976 Eliminator

JPT

Member
Its a 1976 model Eliminator Bubbledeck hull 18ft, with a BBF 460 bored and stroked to a 521, a Berkely pump. The pump has a ss A cut impeller, ss loader, shouldered wear ring, split bowl with a 2" extension, droop snoot, 4* wedge and a manual place diverter. The bowl has 16 studs rather than the normal 8. The interior has all new carpet, new chrome fire ext. with billet mount, new gauge bezels, billet shifter, flush fuel fills w/ bezels, polished diverter control. Also has new shifter cable and new throttle cable. Has two 13 gal tanks, all new Autometer gauges work. Has a BBF 460 bored and stroked to a 521 with 11.5 . 1 compression, crank was cross ground, aluminum chevy howard rods, bottom end was studded and girdled, SCJ heads have been ported and epoxied, the tunnel ram intake has been done the same for an exact match, dual Holley 950hp carbs, all hoses are braided stainless steel, comp roller cam, digital 6 MSD box, MSD Dizzy, advance is locked out, it has Chevy exhaust port adapters, Chevy over the transom headers. I've put around 10hrs run time on the motor since I've had it. Runs on AV gas, 100 octane low lead (have a new 55gal drum with new hand pump and dolley that will go with boat for fuel) Also have some new extra parts for the boat that I bought and just haven't put on yet. Trailer is a '76 model Competitive tandem axle trailer. Just put all new leds on trailer, they work great, has four new tires, new winch and new safety chains. Could use some new boards on the bottom but it hauls the boat fine, I pulled it 6hrs with now problems. All wheels have buddy bearings too. Boat and trailer have new registration and boat has clean Tx title. Bought the boat in late June of this year from Hillbilly68, I have taken this boat out plenty of times on the neches river, it's a blast and its been very relaible.
Picked up another boat two weekends ago so I need to make some room in the shop, 3 is too many.  Have plenty of pics if needed, call (409-466-1619) pm or email me for more info.  Located in Vidor, Tx..  Will take 6,000 obo

2ld9kxi.jpg

177f4k.jpg

33ogrd2.jpg
 

JPT

Member
Ya, I've really enjoyed this boat in the short time that I've had it.  But the new one has my full attention now
 

jdeaton

New member
I would be jumping on that ride EXCEPT I'm in the same (pardon the pun) boat that your in.  Three boats has been declared too many!  I will pass on this ride to my friends that have expressed an intrest in joining the Hot Boat insanity.  Good Luck with the sell.
 

JPT

Member
A '94 Ultra tunnel hull
just a lil sumthin

Ill put a thread with some pics in the members rides
 

Knotty Girl

New member
Might see it on the water somewhere around here then.  clap.gif Congrads. on the sale.  I hope it is my turn soon.
 

525sc777

New member
YEP, MY BROTHER IN LAW JUST PICKED IT UP, WE GOT A LITTLE FRIENDLY RACE COMMIN DOWN THE PIPE LINE, JUST WONDERING WHAT ARE THE #'S FROM THIS BOAT, WILL I NEED NITROUS OR NOT?
 

Knotty Girl

New member
525sc777 said:
YEP, MY BROTHER IN LAW JUST PICKED IT UP, WE GOT A LITTLE FRIENDLY RACE COMMIN DOWN THE PIPE LINE, JUST WONDERING WHAT ARE THE #'S FROM THIS BOAT, WILL I NEED NITROUS OR NOT?

Well I'm not a betting type guy, but I have seen your boat run and I would bet on yours without the spray!  Just say'n
 

sturat

New member
525sc777 said:
YEP, MY BROTHER IN LAW JUST PICKED IT UP, WE GOT A LITTLE FRIENDLY RACE COMMIN DOWN THE PIPE LINE, JUST WONDERING WHAT ARE THE #'S FROM THIS BOAT, WILL I NEED NITROUS OR NOT?
only one way to find out!
 

525sc777

New member
STILL GONNA INSTALL THAT DIRECT PORT FOGGER 300 SHOT JUST IN CASE!!!! BETTER SAFE THAN SORRY, NOT TOO MUCH INTO THE ROOSTER TAIL, JUST IN TO HAULIN ASS MAN!!!!!!
 
Top