and work is dead right now I have been busy too.
just not on my boat,not yet anyways.
first I made up a new exhaust
for now i just did dumps,when i get a bit more time
I will do the two pipes out the back but both together on
passenger side.its very deep but with the dumps its loud inside,
once i get tailpipes it will be perfect. removed last cat thats after the O2
pipe going into that was 3" so I went 3" to muffler and dual 2.5 out.
runs good, I noticed going up the hills into town it wasnt downshifting near top
like it normally does so it is stronger now. tried getting a sound clip but my crappy cameras mic would distort every time , you can click on the best one below but its a big file. ill try and get my buddies good vcam to record a clip later. did all the work in my shop, about 40 for materials and 20 for beer
its all welded, clamp was just to hold it in place while we welded.
http://damncarrera.com/xsport.avi
after getting the exhaust done for now I went ahead today and installed
the Mac rear girdle cover,it was time to chage the gearlube since the rearend is plenty broken in by now so I killed two birds with one stone, went with Synthetic in the rear end and while I was doing it I also did the engine oil since that needed to be done as well. My Bilsteins should be here tommorow so Ill get that done too. Hopefully next week work will be picking up again so trying to get everything done now while I have some down time.
and those of you with sharp eyes will figure out the rest..
:smile13:
too see full size pics just right click and hit "view image" for soem stupid reason this
board resizes pics even when they are on my server.
just not on my boat,not yet anyways.
first I made up a new exhaust
for now i just did dumps,when i get a bit more time
I will do the two pipes out the back but both together on
passenger side.its very deep but with the dumps its loud inside,
once i get tailpipes it will be perfect. removed last cat thats after the O2
pipe going into that was 3" so I went 3" to muffler and dual 2.5 out.
runs good, I noticed going up the hills into town it wasnt downshifting near top
like it normally does so it is stronger now. tried getting a sound clip but my crappy cameras mic would distort every time , you can click on the best one below but its a big file. ill try and get my buddies good vcam to record a clip later. did all the work in my shop, about 40 for materials and 20 for beer
its all welded, clamp was just to hold it in place while we welded.
http://damncarrera.com/xsport.avi
after getting the exhaust done for now I went ahead today and installed
the Mac rear girdle cover,it was time to chage the gearlube since the rearend is plenty broken in by now so I killed two birds with one stone, went with Synthetic in the rear end and while I was doing it I also did the engine oil since that needed to be done as well. My Bilsteins should be here tommorow so Ill get that done too. Hopefully next week work will be picking up again so trying to get everything done now while I have some down time.
and those of you with sharp eyes will figure out the rest..
:smile13:
too see full size pics just right click and hit "view image" for soem stupid reason this
board resizes pics even when they are on my server.
