Recent content by UNCLE SAM

http://dallas.craigslist.org/sdf/boa/3114813249.html Whaler Jet

My wife is skating in the championship bout for her leauge.   Link to info              http://ntderbyrevolution.com/training/events/   Some video of last bout                http://www.youtube.com/watch?v=1EKlcOtS4dw

Need to get rid of the Quadrajets & go Holley. The boat is a Welcraft Nova II like 26 ft. Twin small blocks with a little cam in them. Don't know the cam specs. Have not had it on the water yet. (yeah I know lotsa good info) Big heavy boat, Alpha 1's I am thinking 650 double pumpers. What do...

Anyone In the Dallas area got one you can part with?

Tried to put my pump together yesterday & ran in to a little problem. I couldn't get the gap between the impeller & the wear ring even close to where it needs to be. I usually try to get to .025. I am at like 1/8 of an inch. The thrust bearing is pressed all the way to the shoulder on the shaft...

I am looking for a couple of feet of 3/8 & 1/2 od tube. Anybody know where to buy it without getting a whole 25 ft roll? Home Depot used to sell it but no more.

crazy.gif

I have a Torker that is in nice shape has not been modified. Also have a Performer, plenum divider has been cut down, port matched to Mr Gasket ultra seal gasket, has a hole behind the carb that is 1/2 NPT this is where I had my pcv valve. I will get some pics posted $125.00 for either one...

Out comes the rotten floor This is what I used to get most of it out. I did the edges with a 4 inch grinder Cleaned up & ready to work Cardboard templates Test fitting wood

Have a 750 Marine vac secondary / need electric pump, regulator, filter. Trade ?

:smile13:  [b]    SOLD!!!

Boat is a Taylor SS. 455 Olds, Berk JE.  I am spinning an American Turbine AA impeller 5 grand with no problem. The boat runs 59-60mph (GPS) at this RPM. I am thinking I should have more MPH at this RPM or should not be able to turn the AA that high. The pump is fresh 0.25 clearance on the...